Toshiba 27HLV95 - Manual (Page 19)

Chapter 2: Connecting your TV
19 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 27HLV95 *Web 213 : 276
S-VIDEO
OUT
VIDEO
OUT
AUDIO
OUT
COMPONENT VIDEO
L
R
P B P R Y
IN from ANT
VIDEO AUDIO
OUT to TV
CH 3
L R
L R
CH 4
IN
OUT
OUT OUT
IN Signal splitter
Connecting a DVD player with ColorStream ® (component video) and a VCR
From antenna or Cable Your TV has ColorStream ® (component video) inputs.
You will need:
one signal splitter
three coaxial cables
two sets of standard A/V cables
• For better picture performance, if your VCR has S-video, use an
S-video cable (plus the audio cables) instead of the standard
video cable. However, do not connect both types of video cable to
VIDEO 1 at the same time or the picture performance will be
unacceptable.
• If you have a mono VCR, connect L/MONO on the TV
(VIDEO 1) to your VCR’s audio out terminal using the white
audio cable only.
one pair of standard audio cables
one set of component video cables
• You can connect the component video cables (plus audio
cables) from the external DVD player to set of ColorStream
HD terminal on the TV. The ColorStream HD terminal can be
used with Progressive (480p, 720p) and Interlaced (480i,
1080i) scan systems. A 1080i signal will provide the best
picture performance.
• If your DVD player has HDMI video, see page 21.
To view antenna or Cable channels:
Turn OFF the VCR. Select the ANT 1 video input source
on the TV.*
To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD
video input source on the TV.*
To view the VCR:
Turn ON the VCR. Select the VIDEO 1 video input
source on the TV.*
To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to
record. Select the ColorStream HD video input source on
the TV* to view the DVD.
_____________
* To select the video input source, press INPUT on the remote control
(see page 60). To program the TV remote control to operate other
devices, see Chapter 3.
DVD player with
component video
Stereo VCR
TV lower back
panel
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1, ANT 2,
VIDEO 1, and VIDEO 2 terminals when the appropriate input mode is selected.
The playing disc’s contents by the DVD section are not output.
TV upper back panel
To use the TV Guide On Screen ™ recording features:
1. Connect the G-LINK™ cable according to the
instructions on page 23.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your VCR
owner’s manual for details), and then turn OFF the VCR.
4. See Chapter 5 for details on setting up the TV Guide
On Screen ™ system.
5. See Chapter 7 for details on using the TV Guide
On Screen ™ system.
#01E_015-024_27HLV95 05.10.6, 10:35 AM 19
Black