Toshiba 27HLV95 User Manual

Page 11

(E) 27HLV95 *Web 213 : 276

1. Carefully read the important safety, installation, care,

and service information on pages 2–7. Keep this
manual for future reference.

2. Observe the following when choosing a location for the

TV:

• Place the TV on the floor or a sturdy, level, stable surface that

can support the weight of the unit. Secure the TV to a wall,
pillar, or other immovable structure as described on page. 3,
item 19.

• Place the TV far enough from walls and other objects to allow

proper ventilation. Inadequate ventilation may cause
overheating, which will damage the TV. THIS TYPE OF
DAMAGE IS NOT COVERED UNDER THE TOSHIBA
WARRANTY.

• The disc slot side should be far enough from walls and other

objects to allow loading/unloading a disc.

• Read “Installation” on pages 3–4.

• Read “Important notes about your LCD TV/DVD Combination”

on page 5.

3. Do not plug in any power cords until AFTER you have

connected all cables and devices to your TV.

4. BEFORE connecting cables or devices to the TV, learn

the functions of the TV’s connections and controls (pages 12
and 13).

5. Connect your other electronic device(s) to the TV

(pages 15–24).

6. Connect the G-LINK™ cable (either one of the enclosed IR

blaster cables) from your VCR and/or Cable box (if applicable) to
the G-LINK™ terminal so you can use the TV Guide On Screen

™

features (applies to VCRs and cable boxes only). See page 23.

7. Install the batteries in the remote control (page 26).

8. See “Learning about the remote control” (page 25) for

an overview of the buttons on the remote control.

9. Program the remote control to operate your other

device(s) (pages 29–30).

10. AFTER connecting all cables and devices, plug in the

power cords for your TV and other devices.
“Now Booting...” will be displayed on the screen until the picture
appears or the green LED will blink until the TV goes into
standby mode.
When the TV is in standby mode, press POWER on the top panel
or remote control to turn on the TV.

If the TV stops responding to the controls on the remote control or
TV top panel and you cannot turn the off or on, press and hold
the POWER for 5 seconds to reset the TV.

11. See “Menu layout and navigation” for a quick overview

of navigating the TV’s menu system (pages 33–34).

Overview of steps for installing, setting up, and using your new TV

Follow these steps to set up your TV and begin using its many exciting features.

Chapter 1: Introduction

12. See Chapter 5 for details on setting up the TV Guide

On Screen™ system (if available in your area).

13. See Chapter 7 for details on using the TV Guide

On Screen™ program guide (if available in your area).

14. Program channels into the TV’s channel memory

(page 40).

15. For details on using the TV’s features, see Chapter 8.

16. For details on using the DVD’s features, see Chapter

10.

17. For help, refer to the Troubleshooting Guide (Chapter

11).

18. For technical specifications and warranty information,

see Chapter 12.

19. Enjoy your new TV/DVD!

Note: If you sell or transfer this television to a third party, be sure to
reset the PIN code as described on page 80 under the heading, “If
you cannot remember your PIN code.”

#01E_010-011_27HLV95

05.10.6, 10:31 AM

Black