Trango Broadband High Density Mesh System - Manual (Page 20)

HD Mesh Node
Trango Broadband Wireless — High Density MESH page 20
Section 4 Basic Configuration via Winbox
This section describes how to configure basic settings using Winbox. This section is written to
address only the basic steps. It is highly recommended that you visit and read Mikrotik’s website to gain an
understanding of all important configuration parameters.
In this section you will learn the following:
• Configure an IP address
• Configure Wireless Card
• Configure Firewall
• Configure DHCP Server
• Configure OSPF
Configuring an IP address
Once you have logged into Winbox the Menu bar on the left will appear. Clicking on the IP and then
addresses will display all interfaces and IP addresses of the interfaces. (Figure 19)
Figure 19
Double clicking on the IP address will bring up the IP address configuration window. Select the
interface; assign an IP address followed by a slash and the bits of the subnet mask. If you provide the bits of
the subnet mask the Network and Broadcast will be populated automatically once apply is clicked. Multiple IP
addresses can be assigned to a single interface. (Figure 20)
Figure 20