Texas Instruments TMS320DM6446 DVEVM v2.0 - Manual (Page 26)

Running the Standalone Demos
3-6
3.3.2 About the Encode + Decode Demo
The Encode + Decode demo allows you to record and playback video.
Video comes from the camera, is encoded, then decoded, and then sent
to the LDC display.
The Encode + Decode does only video processing; it does not encode
and decode audio or speech. The supported video algorithm is H.264
Baseline Profile (.264 file extension).
The application runs on the ARM using Linux. The video signal is passed
to video encoders and decoders on the DSP by the Codec Engine.
Shared memory is used when passing data.
To use this demo from the command line, see Section 3.4, Running the
Demos from the Command Line.
Table 3–1 IR Remote Buttons for Encode + Decode Demo
IR Remote Button Mode Action Performed
Up/Down -- -- no action --
Play or OK Setup Begin demo
Record -- -- no action --
Info/Select Setup Show / hide block diagram for demo
Info/Select Run Toggle information display
Left/Right Run Change information transparency level
Pause Run Pause demo (press Play to resume)
Stop Setup / Run Return to previous screen