Texas Instruments TMS320DM6446 DVEVM v2.0 User Manual
Page 16
Setting Up the Hardware
2-2
2.1
Setting Up the Hardware
To set up the hardware provided with the EVM, use the steps in the
sections that follow. You may skip sections if you do not need to access
a particular peripheral. For example, if you do not need to use the serial
cable, skip that section.
1) The EVM is sensitive to static discharges. Use
a grounding strap or other device to prevent
damaging the board.
Be sure to connect communication cables
before applying power to any equipment.
2) If you use PAL video, set switch 10 on the S3 (USER) bank of
switches to On. If you use NTSC video, set this switch to Off. See
Figure 1–1 for S3 switch bank location.
3) Connect the yellow video cable to the upper-right Video Out jack on
the EVM and the LCD display Video Input as shown below.
See Section A.1, Changing the Video Input/Output Methods for
information about using S-Video or Component video.