Toshiba 51H94 - Manual (Page 27)

(E) 51/57H94
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved. 27
Chapter 3: Using the remote control
MODE Device mode control after programming
1) TV Toshiba TV
2) CBL/SAT
3) VCR/PVR
4) DVD
Multi-brand video/audio devices
5) AUDIO 1
6) AUDIO 2
Note:
Although your new TV’s remote control includes
codes for many devices, it may not include
codes for some or all of the features on certain
devices you wish to control. If you are unable to
program the TV’s remote control to operate
your device or some of the features on that
device, use the device’s remote control or the
controls on the device.
MODE
ACTION
ENTER
MENU
–
100
+10
Your TV remote control has one dedicated TV mode and five programmable
multi-brand modes: CBL/SAT, VCR/PVR, DVD, AUDIO 1, and AUDIO 2.
The default device modes and programmable device modes are listed below.
Note: The TV remote control is preprogrammed to operate most Toshiba devices.
If you own a non-Toshiba device or a Toshiba device that the remote control is not
preprogrammed to operate, you will need to program the remote control. See
“Programming the remote control to operate your other devices” on page 30.
MODE Default device mode control (before programming)
1) TV Toshiba TV
2) CBL/SAT Toshiba Satellite receiver
3) VCR/PVR Toshiba VCR
4) DVD
Toshiba DVD
5) AUDIO 1 Pioneer Audio receiver
6) AUDIO 2 Pioneer LD
Using the remote control MODE button to control your other devices
To install the remote control batteries:
CAUTION: Always dispose of batteries in a designated disposal location.
Never throw batteries into a fire.
1. Slide the battery cover off the back of the remote control.
2. Install two “AA” size alkaline batteries. Match the + and – symbols
on the batteries to the symbols on the battery compartment.
3. Slide the battery cover on to the remote control until the lock
snaps.
Installing the remote control batteries
You can directly select the device mode by pressing the corresponding
number button (1-6) while pressing the MODE button.
Number (1-6)
Note:
• Batteries should always be disposed of with the environment
in mind. Always dispose of batteries in accordance with
applicable laws and regulations.
• Never mix battery types or use new and used batteries in
combination.
• When necessary to replace batteries in the remote control,
always replace both batteries with new ones.
• Always remove batteries from remote control if they are
dead or if the remote control is not to be used for an
extended period of time. This will prevent battery acid from
leaking into the battery compartment.
Remote control effective range
H94(E)026-33(3-RC) 8/3/04, 3:54 PM 27