TANDBERG D13841.01 - Manual (Page 16)

TANDBERG 3G Gateway User Manual
16
To configure the IP number follow the instructions below:
1. Press any key to get the main menu.
2. IP settings should be displayed.
3. Press [ENTER] to access the IP settings menu.
4. Us the [UP/DOWN] key to select IP Address.
5. Press [ENTER] to access the IP address editing menu.
6. Press [ENTER] again to get a cursor.
7. Use up down keys to navigate between the different digits.
8. After selecting a digit use the [ENTER] key in combination with the [UP/DOWN] key to change the
digit value.
9. When finished editing use [ESC] key to go to the confirm change menu.
10. Use the [UP/DOWN] key to select yes or no and [ENTER] to confirm.
11. Use [ESC] key to navigate back to the main menu.
Note that DHCP assigned IP-addresses are supported by the TANDBERG 3G Gateway (factory default),
3G Gateway start-up
To start the 3G Gateway, please make sure that the power cable is connected, and press the
power switch button at the back side to
‘
1
’
.
On the front panel of the system the power indicator LED, marked
‘
Pwr
’
, will turn GREEN.
Accessing the 3G Gateway
You may access the 3G Gateway by entering the IP-address of the 3G Gateway in a standard
WEB-browser. You will then be asked to enter a password. It is not necessary to enter
‘
User
Name
’
. The default password for the 3G Gateway is
‘
TANDBERG
’
. Remember that the password
is case sensitive. Note that it also possible to use SSH and Telnet to configure the 3G Gateway.