Telular Wi PATHTM SX7T Terminal and SX7M Modem EVDO User Manual

Page 23

Basic (cont.)

RJ-11 Jack Mode

Select a configuration for the Phone jack (J1) and the
Fax jack (J2):

J1 Voice, J2 Voice to set both jacks for voice calls only
(default setting).
J1 Voice, J2 FAX to set the phone jack for voice calls
and the fax jack to send and receive fax data.
J1 Voice, J2 Data to set the phone jack for voice calls
and the fax jack for CSD data calls.

One Minute Alert Beep

Select Enabled to hear a beep once every minute during
a voice call.

Voice Privacy Tone

Select Enabled to hear an alert tone if Voice Privacy
encryption is not available during a voice call.

Call Control

Dialtone after Remote Disconnect

Select Enabled to hear a dial tone if a call is terminated
from the other end.

Auto Send Delay

Delay between when you finish dialing and the call is
sent; select from 0 to 10 seconds (3 seconds is default).

Zero Delay Dialing (EOD)

Select Enabled to have the SX7T remember numbers
you have dialed at least twice and send calls to those
numbers with no delay when you finish dialing.

Glare Control

Select Enabled to enable automatic handling of “call-
collision” (2 calls coming in at the same time).

Dialtone Duration

Length of time a dialtone will remain active when the
receiver is off-hook (10–90 seconds) (40 seconds is
default).

ROH Duration

Length of time the Receiver Off Hook (ROH) tone
will sound after the dialtone duration is complete
(10–90 seconds) (40 seconds is default).

Continuous ROH

Select Enabled to allow for continuous ROH tone until
the unit is returned to the on-hook state.

Exit E911 Mode

Click Exit E911 Mode button to return the unit to normal
state after an emergency 911 call.

Voice and Fax Options (SX7T Only)

Wi PATH

SX7

User Guide