Telular Wi PATHTM SX7T Terminal and SX7M Modem EVDO - Manual (Page 22)

Voice/Fax Programming
The Telular Device Manager allows you to program all the voice and fax options for service on
your SX7T.
1. From your Web browser, launch the Telular Device Manager. (See “Using the Telular
Device Manager” on page 6.)
2. From the home page, click PSTN (1).
3. Click Basic, Call Control, and POTS Setup (2) to display the programming pages (see
“PSTN Options” on page 36 for examples of each page).
4. Select your desired settings (see table below), click Save (3), and then click Restart (4) to
save the settings to your SX7T.
PSTN Settings
Basic
MT Call Type
Select a setting for the phone jack:
Voice Always to use the jack for voice calls only (default
setting).
FAX Next Call to set the jack to send or receive a fax
with the next call (reverts to previous setting after call).
FAX Always to use the jack for fax calls only.
Data Next Call to set the jack to send or receive Circuit
Switched Data (CSD) with the next call (reverts to
previous setting after call).
Data Always to set the jack for CSD data calls only.
TTY Mode
Allows the unit to be used with TTY (TeleTypewriter)
devices for the deaf or hard of hearing. Modes include
TTY VCO (voice carry over), TTY HCO (hearing carry
over), and TTY Only.
3 3 4
1
2
Voice and Fax Options (SX7T Only)
Wi PATH TM SX7 20 User Guide