Telular Wi PATHTM SX7T Terminal and SX7M Modem EVDO - Manual (Page 16)

USB Connection Option
Wi PATH TM SX7 14 User Guide
Connect the SX7 to Your Computer With a USB Cable
1. With your computer and the SX7 powered on, connect the terminal end of the USB cable
to the USB Type B Port on the SX7.
2. Connect the other end of the USB cable to an available powered USB Type A port on
your computer.
3. A Found New Hardware Wizard will open. Select “Install the software automatically
(Recommended)” and click Next.
If a Windows Logo testing warning appears, click Continue Anyway.
4. Click Finish to complete the installation.
Set Up a Dial-Up Networking (DUN) Connection
1. With the drivers and USB modem installed and connected, click Start > Control Panel >
Network Connections.
2. Click File > New Connections.... (The New Connection Wizard will start.)
3. Select the following settings and click Next after each selection:
Connect to the Internet.
Set up my connection manually.
Connect using a dial-up modem.
Set up my connection manually.
Note The USB host (Type A) port on the SX7 is not currently active. It is reserved for future use
USB
(Type B)