TOA Electronics EXES 6000 CP-63 - Manual (Page 53)

Pocket Pager
The system can be connected with usual type Pocket pager
using the interface with Make/break relay output.
1. Dial
and the pager is called after confirmation tone is heard.
2. When
is dialed by the party called from the nearest master
station, it is possible to respond a call to the station.
Note.
1. Once a receiver is called from one station and a
response is waited for, camp-on-busy will result for
other callers. But, if a response to the call is not
received within 3 minutes, the terminal can be called
from a new calling station.
2. If the pager is called after confirmation tone is heard,
a calling station is disconnected from the speech line
and waits for a response while the relay for pager
transmission is kept in the Make position till a
response is made. The station which waits for a
response can be called from the other stations.
3. The other stations can call the other pagers while one
station makes a call and is waiting for a response.
4. Dialing (pager number that is called)
cancells calling the pager if the wrong number has
been pressed.
5. When the exchanges are connected by tie-lines, it is
only possible to call the pager from the stations con-
nected to the exchange "A" for stations No. 200
through 327. A pager response can be made from any
station.
Pager transmitter
Pager call
Pager receiving call
Response call
Response
(From the nearest station)
Data transmitting/
receiving unit
Pager transmitter
Exchange A
No.200~327
Exchange C
No.740~867
Exchange B
No.470~597
Pager terminal called
Response
(From the nearest station)
— 52 —