TechniSat MultyFocus - Manual (Page 15)

5.7 Decoder/OSD
If your television is equipped with RGB inputs you can select the OSD display to achieve optimal quality of character
display.
Warning:
This requires a
correctly wired (21-pin) SCART cord!
> Display the installation menu (see p. 8).
> Press to set pointer to „Decoder/OSD“
> Press .
> Press to set
pointer to “TV SCART“.
> Press
to select „RGB“.
> Press to return to the installation menu.
The „MAC/Eurocrypt“ and „Videocrypt“ functions are intended for service purposes only.
5.8 Childproof control feature
To secure the receiver against unauthorised use you can enter a secret code. Later on, this secret number is
requested during normal operationany time you want to watch channels which are marked accordingly (see 6.8,
„Childproof control feature“), or if you change your settings, e.g. when displaying the installation menu. To be able to
control the receiver in cases where you have forgotten your secret number, you can use the global access number
which is valid all the time. Check the last page of this manual to find out your global access number.
> Display the installation menu (see p. 8).
> Press to set pointer to „Kindersicherung“ (childproof control feature).
> Press .
> Enter the four digit secret code over the ten-key keypad (identical with the global access number if you have not
defined any other number, so far).
> Enter the new four
digit secret number
over the ten-key
keypad.
> Repeat the secret
number over the ten-
key keypad.
> After a few seconds the receiver automatically returns to the installation menu.
OK
OK
15
Decoder/OSD
MAC/Eurocrypt no
Videopcrypt no
> TV scart PAL
motor type A
^/v//OK/STOP
STOP
Childproof control
> access code
new access code
repeat new access code
0-9/STOP
*M-Focus 2.6.95 14.12.1999 10:34 Uhr Seite 15