TechniSat MultyFocus - Manual (Page 13)

5.5 Automatic satellite scan
The automatic satellite scan feature only works from West to East. The following explanation assumes that
the reflector has been oriented towards the westernmost satellite (Hispasat 1 at 30° West in our example)
after having set up the East and West limits (see 5.4).
Satellites which are located beyond the East and West limits can not be selected by the automatic
satellite scan. For this, you may need to extend the trajectory limits (see 5.4).
First of all, select the type of motor you Are using: A for PFA reflectors with actuator, or B for offset reflectors
with H/H mount.
> Press to set pointer to „Decoder/OSD“.
> Press .
> Press to set
pointer to „motor
type“.
> Press to
toggle between A
and B
> Press to return to
the installation menu.
> Press to set
pointer to „automatic
satellite scan“.
> Press .
> Press to set
pointer to „satellite“.
> Press to switch
over to the next
satellite West (Intelsat
601 at 27.5° West in
our example).
> Press to tur n off
background.
> Briefly press .
The antenna moves West to search for channels on the selected satellite. Once the receiver has found a satellite, it
stops to find the best peak position (auto-focus).
> Press to set pointer to „Programm“ (channel).
> Press to select and check if the receiver has found the desired satellite.
Warning: Not all satellite channels have permanent broadcasts. Also, the frequency mapping may vary from time to
time. Check the most recent publications, such as the „Infosat“ magazine which is issued monthly.
When the desired satellite has been found:
> Press to set pointer to „Gesp. Position“ (stored position).
> Press to store.
> Scan and store additional satellites east of the previous one, and follow the instructions above.
OK
OK
OK
13
Decoder/OSD
MAC/Eurocrypt no
Videopcrypt no
TV scart PAL
> motor type A
^/v//OK/STOP
Automatic satellite scan
> satellite Hispasat 1 30W
channel TDeporte 12.149 GHz
stored position
4816
antenna position 4816
start scan
auto-focus
LNB input
1
optimise skew 132
^/v//MENU/OK/STOP
Automatic satellite scan
satellite Intels.601 27,5W
channel TravelCh 11.175 GHz
stored position
antenna position
4816
start scan
auto-focus
LNB input
1
optimise skew 132
^/v//MENU/OK/STOP
MENU
*M-Focus 2.6.95 14.12.1999 10:33 Uhr Seite 13