Tascam BD-R2000 - Manual (Page 12)

12
Getting Started
Rack Mounting Notes
If this product is to be used without being rack-mounted,
please affix the enclosed FOOT parts to the bottom face of
the unit.
Attaching the FOOT parts.
• Carefully turn the unit upside down.
• Removing the seal from each FOOT part exposes a self-
adhesive surface.
• Attach one FOOT part to each of the 4 places noted in the
diagram.
• Turn the unit back to its normal orientation.
FOOT
Precautions for placement
and use
Precautions When Mounting Rack
• The guaranteed operating temperature range of this prod-
uct is 5º - 35º C (41º- 95º F).
• Do not install in the following types of places. Doing so
could degrade the image quality and/or cause malfunctions.
• Places with significant vibrations or that are otherwise
unstable
• Near windows or other places exposed to direct sunlight
• Near heaters or other extremely hot places
• Extremely cold places
• Places with bad ventilation or high humidity
• Make sure that the unit is mounted in a level position for
correct operation.
• In order to promote the emission of heat, do not place
anything on top of this product.
• Do not place this product on top of a powered amplifier or
other equipment that emits heat.
• When using rack mount, keep the clearance between the
rack and the rear of unit 150mm or more.
• When installing this unit or the like to the rack, refer to the
consumption current value of the nameplate of each device
so that the current capacity (including rated capacity of
power supply wire) of the rack is not exceeded.
• Use the rack that meets the following requirements:
• must be equipped with overcurrent protection
• must be equipped with protective earthing conductor
power plug and socket