The advanced h.323 settings, Advanced h.323 settings, Site settings – TANDBERG 1D13898.07 User Manual
Page 40
40
D13898.07
NOVEMBER 2008
TANDBERG
CONTENT SERVER
ADMINISTRATOR GUIDE
Site Settings
NAT Address
. The NAT address must be the
global, external address to a router with NAT
support. In the router, the following ports must
be routed to the system’s IP address:
Port 1720
•
The port range specified by the
•
Port Range
field, eg. 3230 to 3270.
Please contact your TANDBERG representative
or authorized reseller for more information.
Use Static Ports
is disabled by
default. This means that the system
will dynamically allocate which ports
to use when opening a TCP/UDP
connection.
Static ports can be enabled by
selecting the checkbox and specifying
the required range of ports.
Port Range
. 3230 to 3270 is the
standard firewall port range. It needs
to be configured according to your
local firewall settings.
NAT
. Network Address Translation is
used when the Server is connected to
a router with NAT support. The default
setting for NAT is
Off
.
If NAT is
On
, the system will signal
the configured NAT address in place
of its own IP address within Q.931
and H.245.
If NAT is set to
Auto
, the system will
try to determine whether the NAT
address or the real IP address should
be used for signaling. This is done
to make it possible to make calls
to endpoints on the LAN as well as
WAN.
The Advanced H.323 Settings
Changes to any fields in this
section require you to Restart
Service.
Changes to any fields in the
Advanced
H323 Settings
section will not take
effect on a given Content Server until all
its calls have ended.