TANDBERG 1D13898.07 - Manual (Page 37)

37
D13898.07
NOVEMBER 2008
TANDBERG CONTENT SERVER
ADMINISTRATOR GUIDE
Table of
Contents
Introduction Installation Quick Setup
TCS
Administration
Backing up and
Restoring
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
Site Settings
Administrators need to review and configure Site Settings
options before putting the system into production.
Site Settings menu items include:
System Information •
Gatekeeper Settings •
Advanced H.323 Settings •
SIP Settings •
Authentication •
API •
User Properties •
System Defaults •
The Site Settings page is automatically refreshed every 10
seconds.
About Site Settings The Site Settings options
The + indicates that this topic is expandable
in the usual way. Once expanded, the sign
changes to – to show that the topic can be
collapsed again.
See System Information section.
See Gatekeeper Settings section.
See Advanced H.323 Settings section.
See SIP Settings section.
See Authentication section.
See API section.
See User Properties section.
See System Defaults section.
All changes made in the Site Settings page need to be confirmed
by clicking the Save button at the top or bottom of the page.
The Site Settings page is available for editing even if the Content
Server is in call. Most settings from the Site Settings page can
be changed and applied while the Content Server is in call.
The exceptions are
Gatekeeper settings , Advanced H323
settings and SIP settings . Any changes made in those sections
will not be applied until all calls on the Content Server have
finished. If calls are in progress when the Save Settings
button was clicked, the Content Server will automatically enter
Configuration Reload mode . In this mode, the Content Server
will not accept incoming calls or make outgoing calls (the Create
Conference interface will display “There are no resources
available to make a call, please try again later”). When the call
or calls currently in progress are completed, new settings will be
applied and the Content Server will be able to receive and make
calls.
The administrator may also choose to override the Configuration
Reload mode and apply changes immediately by clicking on the
End All Calls button in Site Settings, which will terminate calls on
the Content Server.
Applying Site Settings