Toshiba GA-1120 - Manual (Page 14)

1
1-2 Connecting to the Network
Stages of installation on the network
Installation can be performed by a network or printing administrator. The stages of a
successful installation are:
• Physically connecting the GA-1120 to a functioning network
Prepare a network node for the GA-1120—obtain cable, route it to the location where
the GA-1120 will be installed, and attach the cable to the network interface (for
details, see
page 3-9 ).
N OTE : If you plan to run Command WorkStation software, you will need to install the
software and connect the Command WorkStation computer to the network along with
the GA-1120. For more information, see the
User Software Installation Guide .
• Configuring the network server
When network servers are required, you need to configure those servers to provide
client access to the GA-1120 as a color PostScript printer. For information on
configuring network servers in Windows and UNIX network environments, see
Chapter 2 .
• Setting up the GA-1120
Configure the GA-1120 for your particular printing and network environment.
First read
Chapter 2 , and then see subsequent chapters for details.
• Preparing client workstations for printing
Install the files needed for printing, install additional user software, and connect the
client to the GA-1120 over the network. These steps are described in the
User Software
Installation Guide , and some information is also provided in Chapter 2 .
• Administering the GA-1120
Monitor and maintain system performance and troubleshoot problems that arise.
For details, see
Chapter 7 of this manual and the Job Management Guide .