Toshiba F25Series - Manual (Page 105)

105 Learning the Basics
Powering down the computer
5.375 x 8.375 ver 2.3
❖ When I close the lid
Set this option to Hibernate so that the computer will
go into Hibernation mode when you close the display
panel.
7 Click Apply.
8 Click OK to close the TOSHIBA Power Saver Properties
window, then close the Control Panel.
Once the computer is configured, place the computer into
Hibernation mode by either pressing the power button or
closing the display panel, depending on the hibernation
options selected.
Starting again from Hibernation mode
Use these instructions to restart the computer when you enter
Standby mode by closing the display panel:
❖ AC power. Open the display panel.
❖ Battery power. Open the display panel and press the
power button until the on-off light changes to green and
the power button glows blue.
The computer returns to the screen you were previously
using.
Using Standby Mode
The Standby command puts the computer into a power-
saving mode. Standby stores the current state of the computer
in memory so that, when you power on the computer, you can
continue working from where you left off.
Factors to consider when choosing Standby:
❖ While in Standby mode, the computer uses some battery
power. If your computer is left in Standby mode for an
extended period, your computer could lose data.
❖ Restarting from Standby uses less time and battery power
than restarting from Turn Off or Hibernation mode.