beautypg.com

TANDBERG D1320203 User Manual

Page 21

background image

TANDBERG 3G Gateway

Data port Command Interface User Guide

OPC: <0 .. 16383>

NetworkIndicator:

Law:

LinkSet [1 .. 2] Mode:

LinkSet [1 .. 2] DPC: <0 .. 16383>

LinkSet [1 .. 2] Link [1 .. 2] Mode:

LinkSet [1 .. 2] Link [1 .. 2] Trunk: <1 .. 4>

LinkSet [1 .. 2] Link [1 .. 2] Timeslot: <1 .. 31>

LinkSet [1 .. 2] Link [1 .. 2] SLC: <0 .. 15>

Trunk [1 .. 4] Mode:

Trunk [1 .. 4] DPC: <0 .. 16383>

Trunk [1 .. 4] CircuitIdentificationCode: <0 .. 16383>

Route [1 .. 8] DPC: <0 .. 16383>

Route [1 .. 8] Priority: <1 .. 4>

Route [1 .. 8] LinkSet:


---

sub-commands:

OPC: A number between 0-2

14

, which uniquely identifies a signaling point, in this case the

3G Gateway, within a telephone network. This number consists of three parts, i.e. a network,
cluster and member number, and will be provided by the network operator.

NetworkIndicator:,A two bit data field within the Service Information Octet of the

Message Signal Unit that permits discrimination between national and international
messages.

Law: audio standard: Either ALAW or ULAW. An a-law algorithm is a standard

companding, i.e. compressing and expanding, algorithm, used in European digital
communication systems to optimize, i.e. modify, the dynamic range of an analog signal for
digitizing. The µ-law algorithm is similar to a-law and used in North American and Japanese
systems.

LinkSet Mode: Enable or disable linksets.

LinkSet DPC: Uniquely identifies the destination signaling point of the link. This can differ

from the DPC of the trunk, e.g. the DPC of a Signaling Transfer Point (STP), see example 2
below.

LinkSet Link Mode: Enable a link in a link set.

LinkSet Link Trunk: Number of the trunk (1 - 4) in which a time slot is reserved for

signaling.

LinkSet Link Timeslot: Number of the time slot, within aforementioned trunk, reserved for

signaling.

LinkSet Link SLC: A Signaling Link Code is a unique link number provided by the

network operator to identify a link.

Trunk Mode: Enable or disable a trunk.

Trunk DPC: Uniquely identifies the destination signaling point of the trunk. It will be

provided by the network operator.

D1320203

21