TANDBERG D1320203 User Manual

Page 18

TANDBERG 3G Gateway

Data port Command Interface User Guide

SNMP HostIPAddr [1..3]:
---

parameters:

• Mode: < On/Off/ReadOnly/TrapsOnly >

• Community Name: Text string of maximum 16 characters.

• System Contact: Text string of maximum 70 characters

• System Location: Text string of maximum 70 characters

• Host IP Addr: The IP addresses of max 3 SNMP trap hosts

sub-commands:

• Mode enables or sets the mode of SNMP support

• Community Name is used to authenticate SNMP requests. SNMP requests must have

this ‘password’ in order to receive a response from the SNMP agent in the 3G Gateway.

• System Contact, Used to identify the system contact via SNMP tools such as

HPOpenView or TANDBERG Management Suite

• System Location Used to identify system location via SNMP tools such as

HPOpenView or TANDBERG Management Suite

• Host IP Addr identifies the IP-address of the SNMP manager. Up to three different

SNMP Trap Hosts can be defined. Your LAN administrator should provide the correct
values for these fields

Example of SNMP feedback:
*c xConfiguration SNMP Mode: On
*c xConfiguration SNMP CommunityName: "public"
*c xConfiguration SNMP SystemContact: ""
*c xConfiguration SNMP SystemLocation: ""
*c xConfiguration SNMP HostIPAddr 1: "127.0.0.1"
*c xConfiguration SNMP HostIPAddr 2: "127.0.0.1"
*c xConfiguration SNMP HostIPAddr 3: "127.0.0.1"

SSH

Enables or disables SSH interface on the 3G Gateway

SSH Mode:
---

Example of SSH feedback:
*c xConfiguration SSH Mode: On

SystemUnit

Sets the 3G Gateway name and password

SystemUnit Name:
or
SystemUnit Password:
---

Parameters:

• Name: Text string of maximum 50 characters

• Password: Text string of maximum 16 characters

sub-commands

• Name, sets the name of the 3G Gateway

• Password, sets the password of the 3G Gateway

Example of SystemUnit feedback:
*c xConfiguration SystemUnit Name: ""

D1320203