Setting up the software, 2 setting up the software – Texas Instruments 660 User Manual
Page 29
Installation
2-3
Figure 2-1 Memory Expansion Removal/Replacement
Note: After installing expansion memory in your notebook, you must run the
PHDISK utility in order for the Save-To-Disk or 0V Suspend functions to operate
correctly.
2.3.2 Setting up the Software
Note: If you are using an operating system other than Windows 95, Windows for
Workgroups, or DOS, you may need to re-partition your hard disk drive to allow
for the additional memory. Check with your system administrator.
Memory Expansion
Compartment With
Cover Removed
soDIMM
Socket
Installing soDIMM
in Socket