ASSISTANT AH-1076 User Manual

Page 2

Hand on top of sensor (6) within 1 second to show the alarm 2 time.
2. The radio On mode, use the Infrared sensor to turn sleep

function on

Hand on the top of sensor (6) within 2 seconds to turn the

sleep on, the word “Slp” showing on the LED display. Sleep time
from 10-90 minutes. (Refer to page 9 for require sleep time ad-
justment). Press (9) to cancel sleep function.

3. The alarm On mode, use the infrared sensor to turn snooze

function on

Hand on top of sensor (6) within 1 second snooze off for 9

minutes.

THE LED DIGITAL CLOCK AND THE PROJECTION

CLOCK MUST BE SET SEPARATELY

TIME SETTING FOR PROJECTION UNIT

To preset the HOURS, press simultaneously the HOUR Button

(25) and the TIME button (26). Hold them pressed until the hour
digits to be preset are displayed.

To preset the MINUTES, press simultaneously the MINUTE

Button (24) and the TIME button (26). Hold them until the minute
digits to be preset are displayed.

ENGLISH

– 10 –

ENGLISH

WARNING: To reduce the risk of life or electric shock do not

expose this appliance to rain or moisture.

NOTE: Do not connect FM antenna to outside antenna.

Dripping warning: “The product shall not be exposed to drip-

ping or splashing and that no objects fi lled with liquids, such as
vases, shall be placed on the product”.

Ventilation warning: “The normal ventilation of the product

shall not be impeded for intended use”.

Disconnect device warning: Main plug is used as the connec-

tion, so it should always remain ready operate.

INFRARED SENSOR FUNCTION

1. The radio Off mode, infrared display alarm 1 and alarm 2

time

Hand on top of sensor (6) within 1 second to show the alarm

1 time.

RESET

The reset button (17) is located on the back of unit. Use a ball-

point pen to press it whenever you want to change the batteries,
or unit is not performing as expected. This will return all settings
to default value, and you will lose any stored data (alarm and
clock settings)

CAUTION

No naked fl ame sources, such as lighted candles, should be

placed on the apparatus.

Do not place the unit in closed bookcases or racks without

proper ventilation.

To prevent fi re or shock hazard, do not expose unit to rain or

any type of moisture.

The unit should not be exposed to direct sunlight, very high or low

temperature, moisture, vibrations or placed in a dusty environment.

Do not use abrasive, benzene, thinner or other solvents to

clean the surfaces of the unit. To clean, wipe it with mild non-
abrasive detergent solution and clean with soft cloth.

Never attempt to insert wires, pins or other such objects into

the vents or opening of the unit.

Do not place the unit near the light on table lamp. The light

will aff ect the reception of the infrared sensor function.

SPECIFICATIONS

Frequency range:

AM 530 – 1600 kHz FM 88 – 108 MHz

Output power:

350mW

Speaker impedance: 8 ohm

Battery backup:

9V (3Ч3V CR2025 Flat Lithium battery)
(Not included)

Power source:

AC 230V – 50 Hz, 5 watts

ENGLISH

– 11 –

ENGLISH

Focus setting: Adjust the projection clock brightness/focus

by turning the brightness/focus adjustment wheel (27) until the
projected time is clearly shown on the ceiling or wall.

NOTE:
PROJECTS TIME IMAGE ON THE CEILING OR WALL OF A DARKENED ROOM.
MAXIMUM PROJECTION DISTANCE IS 3-9 FEET.

ENGLISH

– 12 –

ENGLISH

– 13 –

ENGLISH

– 9 –

ENGLISH