Toshiba TLP780E User Manual
Page 36
36
Operations
MENU
ON/STANDBY
INPUT
L-CLICK
R-CLICK
ENTER
KEYSTONE
AUTO
SET
EXIT
PIP
FREEZE
MUTE
CALL
RESIZE
VOLUME/ADJUST
LASER
4,5
6
6
4,5
K
EY
ST
O
N
E
AU
TO
SE
T
EXIT
ON / STANDBY
VOL / ADJ
ENT
ER
M
EN
U
IN
P
U
T
FAN
TEMP
LAMP
ON
Remote control
Control panel
(Main unit side)
Correcting the keystone distortion (continued)
4
If the screen is not installed vertically,
“Auto. V-keystone” is not corrected
properly.
After confirming that “V-keystone” is selected on the menu;
Adjust the distortion of the both sides (right and left)
of the picture with the selection buttons ( / ).
5
When the projector is not installed at an angle of 90
°
to the
screen viewed from the top, the upper and lower sides of the
projected picture will be
distorted.
90
°
Select “H-keystone” from the menu with the
selection buttons ( / ), and adjust the
distortion of the upper and lower sides of the
picture with the selection buttons ( / ).
6
Press EXIT repeatedly until the menu
disappears.
The keystone adjustment finishes.
EXIT
EXIT
Notes
• Due to digital correction processing, some of the information may be eliminated or the picture
quality may be degraded depending on the amount of keystone correction or the contents of
the signal source.
• The adjustable range of “V-keystone” or “H-keystone” is influenced by each other’s correction
. Therefore, the correction amount may change when
switching the input.
• When “Auto. V-keystone” does not operate properly even with the screen installed vertically,
execute “Horizontal reference value reset”
.