Toshiba TLP780E - Manual (Page 22)

22
Installation and
connections
CONTENTS
Notes
• The projector cannot be connected to a computer without an analog RGB connector. For details, refer to the computer manual.
• You may not be able to connect some computers to the projector. For details, consult the dealer.
• When connecting to a Macintosh computer, use the supplied Mac adapter (Multiple Scan 21 compatible). For some models the adapter is not required.
• Some computers may have output modes which are not compatible with this projector. Check the compatibility of the connectors, signal levels, timing,
resolutions, etc.
Connecting a computer (COMPUTER IN 1 connector)
You can project the picture from the computer.
Check that the power supplies for the projector and for the computer are off before connecting the cables.
USB COMPUTER IN 1 COMPUTER IN 2
S-VIDEO VIDEO
VIDEO IN
R - AUDIO - L
AUDIO
IN
( Y/P B /P R )
MONITOR
OUT
CONTROL
COMPUTER IN 1 connector
For use as both analog RGB (1) and Y/P
B /P R input. At shipping from
factory, it is set for use as analog RGB (1) input.
AUDIO IN jack
For use as both audio signals for RGB input (analog RGB (1)/analog RGB (2)/
digital RGB) and Y/P
B /P R input.
RGB cable (supplied)
To AUDIO IN jack
Computer
To COMPUTER IN 1 connector
Be sure to connect in the proper
direction.
To monitor port
Audio cable (supplied)
Connecting a Mac adapter for
Macintosh computers (supplied)
ø3.5mm stereo mini-jack
To audio output port