Technicolor - Thomson 605 - Manual (Page 156)

Chapter 5
Expert Configuration
E-DOC-CTC-20050429-0104 v1.0
146
VLAN interface
configuration
Proceed as follows to add or remove Bridged Ethernet interfaces for a certain VLAN:
1 Select the VLAN you wish to edit.
2 A listing of all bridge interfaces will appear, each followed by a drop-down list.
Change the value of the drop-down list to add or remove interfaces from this
VLAN:
(none)
, which means that this interface is not a member of the selected
VLAN.
Tagged
, which means that this interface is a member of the selected
VLAN, and that packets coming in and going out of the SpeedTouch™ will
be VLAN tagged.
Untagged
, which means that this interface is a member of the selected
VLAN, but that the VLAN functionality will be not visible outside the
SpeedTouch™. This means that inside the SpeedTouch™ VLAN will be
used to isolate interfaces from each other, but that outside of the
SpeedTouch™ no VLAN tagging will be used.
3 Click Apply.