Technicolor - Thomson 605 - Manual (Page 140)

Chapter 5
Expert Configuration
E-DOC-CTC-20050429-0104 v1.0
130
5.3.5 RIP
Overview The RIP web page contains three tabs:
Configuration
Interfaces
Neighbours
Configuration The Configuration section allows you to enable/disable the SpeedTouch™ RIP
functionality and configure the some basic RIP settings.
Interfaces The RIP Interfaces table allows you to configure interface specific RIP settings such
as:
Override the master RIP status (enable/disable)
Override the master RIP version, separately for receiving and sending RIP
messages
Specify whether authorization is needed or not, and if so the required
authorization string
Specify whether routed must be included in RIP updates sent to a gateway
from which the updates were learned
Specify whether the interface should transmit RIP updates or not.
Neighbours Optionally, the RIP Neighbours table allows you to define one or more RIP
neighbours. This may be necessary in cases where multicast messages can not be
sent or received among the network.