Placing paper in drawers, P.13 “placing paper in drawers – Toshiba MULTIFUNCTIONAL DIGITAL COLOR SYSTEMS 6520C User Manual
Page 15
1.BEFORE USING EQUIPMENT
Placing Paper 13
1 BEFORE USING EQUIPMENT
Placing paper in drawers
Follow the procedure below to place paper in a drawer. For acceptable copy paper, see the following page:
1
Turn the power of this equipment ON.
y
Up to 600 sheets (64 g/m
2
) (17 lb. Bond) can be placed in one drawer. Be sure that the height of the stacked
paper does not exceed the line indicated inside of the side guides.
y
Fan and jog the stack of paper well before you place it in a drawer, or the sheets may not be separated
before being fed. Be careful not to cut your fingers when fanning.
y
Tidy the paper and place it while aligning it with the right-hand inside surface of the drawer. If there is a gap,
paper misfeeding or size detection failure could result.
y
Place paper with its copy side up. The copy side may be noted on its wrapping paper.
2
Pull out a drawer carefully until it comes to a stop.
3
Push the part shown with an arrow (right side) of the
side guide to unlock it.
4
Place paper in the drawer.