Texas Instruments Extensa 600 Series - Manual (Page 90)

Using System Passwords
5-8
Disabling or Changing a
System Password
To disable or change a system password:
1. Press Fn+F1 (or just F2 during boot) to enter
Setup.
2. Enter your password when prompted.
3. Press the arrow keys to move to
SECURITY
.
4. Move down the screen to a Password
parameter, then press Enter.
Note: You will only be able to change the User
Password if you used the User password to enter
Setup. You will be able to change both the User
Password and the Supervisor Password if you
used the Supervisor password to enter Setup.
5. Enter a new password to set a new password,
or only press Enter with no entries to clear
the password. Verify your entry, then press
Enter.
6. Save the changes then exit Setup.