Texas Instruments Extensa 600 Series - Manual (Page 105)

Startup Error Messages
7-6
Press to resume,
to Setup
q This message is displayed after any
recoverable error message. Press
F1 to start the boot process or F2
to enter Setup and change any
settings.
Previous boot
incomplete - Default
configuration used
q Previous POST did not complete
successfully. POST then loads
default values and offers to run
Setup.
q Run Setup to check for incorrect
settings.
Real time clock error
q Realtime clock fails test.
q This may require board repair.
Contact your dealer or an
authorized service center.
Shadow Ram Failed at
offset:
nnnn
q Shadow RAM failed at offset nnnn
of the 64K block at which the error
was detected.
q Contact your dealer or an
authorized service center.
System battery is dead
- Replace and run
SETUP
q The CMOS clock battery indicator
shows that the battery is dead.
q Replace the battery and run Setup
to reconfigure the system.