Texas Instruments Extensa 600 Series - Manual (Page 44)

Using Disk Drives
2-23
8. Replace the hard disk drive cover by aligning
the release tab with the alignment mark on
the computer and then seat the cover into the
slot making sure the back edge of the cover
is flush with the computer. Make sure the
bottom of the cover is also flush with the
computer.
Aligning the Hard Disk Drive Bay Cover
9. Slide the hard disk drive bay cover to the left
until the release tab snaps into place.
Replacing the Hard Disk Drive Bay Cover
Slide left
Alignment
Mark
Flush
Alignment
Mark