Tandberg Data 7000 - Manual (Page 88)

88
TANDBERG Videoconferencing System Advanced use
Ethernet Speed
Auto The codec will auto-detect the speed/duplex on the LAN.
10/Half The codec will connect to the LAN using 10Mbps speed/Half Duplex.
10/Full 10 Mbps speed/Full Duplex.
100/Half 100 Mbps speed/Half Duplex.
100/Full 100 Mbps speed/Full Duplex.
Restart
Pressing the Quick key ‘Restart’ will restart your system without having to use the On/Off switch on the codec. If
IP-assignment is changed, it is sufficient to use this Quick key to restart the system.
NOTE
SNMP Trap Host
SNMP (Simple Network Management Protocol) is used for monitoring and configuring of different units in a
network. The codec’s SNMP Agent responds to requests from SNMP Managers (a PC program etc.). SNMP
traps are generated by the agent to inform the manager about important events.
SNMP Trap Host identifies the IP-address of the SNMP manager.
SNMP Community
SNMP Community names are used to authenticate of SNMP requests. SNMP requests must have a ‘password’
in order to receive a response from the SNMP agent in the codec.
T HE SNMP C OMMUNITY NAME IS CASE SENSITIVE .
SNMP Settings