Unpacking the base, Unpacking and installing the monitor rack, Tandberg videoconferencing system installation – Tandberg Data 7000 User Manual
Page 14
14
TANDBERG Videoconferencing System
Installation
Unpacking the Base
Due to the weight of the system, the base should be placed in its permanent location as soon as it is unpacked.
Unpacking and Installing the Monitor Rack
Lift the Monitor Rack out of the box. Do not remove the straps or packaging that are around the rack. Place the
rack on top of the base. Make sure that the cables from the base do not get stuck in between.
You will find 4 bolts sticking out at the rear end of the base. Use the 4 nuts to fasten the Monitor Rack in place.
You can now remove the straps and packaging from the Monitor Rack.
Carefully flip down the plastic cover. 4 hexagonal-shaped screws should be used to secure the Monitor Rack to
the top of the Base. There are 2 holes located on each side.
I
F
THE
SYSTEM
IS
TO
BE
PLACED
AGAINST
A
WALL
,
IT
IS
POSSIBLE
TO
REDUCE
THE
SIZE
OF
THE
BOTTOM
PLATE
. T
HE
REDUCTION
SHOULD
BE
DONE
BEFORE
THE
REST
OF
THE
INSTALLATION
IS
CARRIED
OUT
.
T
HE
FRONT
COVER
IS
MADE
WITH
PLASTIC
AND
SHOULD
BE
TREATED
WITH
CARE
.
NOTE
NOTE