Tandberg Data 7000 - Manual (Page 44)

44
TANDBERG Videoconferencing System General use
PC Presenter
Plugging a PC into the system is made extremely simple through the PC Presenter, avoiding the need for any
additional hardware such as a projector, PC/Video converter or extra cables.
• Connect the pre-connected VGA cable to your PC (VGA Output).
• Start your PC.
• Press P C on your remote control.
• Press S ELFVIEW until the indicator ‘Selfview‘ is displayed on your main monitor (single monitor system) or until
you see the PC image on the second monitor.
If no PC image is displayed on your monitor, make sure that your PC transmits the image to the VGA Output, and
that the PC transmits a supported VGA-format (see tip below). Consult your PC-operating manual to see how to
transmit a VGA image from your PC (typically: Fn+F5).
VGA-
FORMATS SUPPORTED
(VESA
COMPLIANT
)
·640X480 60,72,75,85 H Z
·800X600 56,60,72,75,85 H Z
·1024X768 60,70,75 H Z
PC SoftPresenter
PC SoftPresenter is used to display PC images on your system. The system and your PC must be connected to
a LAN. In addition, VNC (Virtual Network Computing) server software must be installed on the PC.
To show the PC image:
• Start the VNC software on your PC.
• Press P
C
on your remote control. Use UP/DOWN to activate PAGE UP/PAGE DOWN on the PC.
For setup information and details, see ‘VNC Settings’ in ‘Advanced use’.
‘PC: VNC’ MUST BE SET IN ‘V IDEO S ETTINGS ’. NOTE