Toshiba 65H93 - Manual (Page 42)

Copyright © 2003 TOSHIBA CORPORATION. All rights reserved. 42
Chapter 6: Setting up your TV
When you press CHANNEL y or z on the remote control or
TV front panel, your TV will stop only on the channels stored
in the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels.
Note:
• If you already programmed channels automatically during the
Quick Connect Guide assisted setup, you can skip to “Manually
adding and deleting channels in the channel memory” on the
next page.
• You must configure the antenna input sources before
programming channels (see page 41).
• The automatic channel programming process does NOT erase
channels that were previously programmed into the TV’s
memory, but adds newly found channels to the existing set of
programmed channels. To remove a channel from the memory,
you must manually delete it (see next page).
• To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
• Programming channels for an antenna input configured for
CABLE will take substantially longer than for an antenna input
configured for ANTENNA. This is normal; however, once
channel programming is completed, you should not have to
repeat the programming process again unless your Cable TV
service lineup changes significantly.
To program channels automatically:
1. Make sure you have configured the antenna input sources.
See page 41 for details.
2. Press MENU and open the SETUP menu.
3. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 4).
Setup
Installation
Sleep Timer
On/Off Timer
Digital Tuner Hold • • • • • • • Off
Slide Show Interval • • • 2 Sec
Convergence
4. Open the TERRESTRIAL menu, highlight CHANNEL
PROGRAM, and press ENTER.
5. Highlight ANT 1 or ANT 2, depending on which antenna
input you want to program channels for, and then press
ENTER to start automatic channel programming.
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
ANT 1
ANT 2
ANT 1 Cable
Scanning channels, please wait...
Abort
0%
i
The TV will automatically cycle through all the channels
for the antenna input you selected, and store all active
channels in the channel memory. While the TV is cycling
through the channels, the message “Scanning channels,
please wait” appears (as shown above right).
To cancel channel programming, highlight ABORT and
press ENTER.
6. When channel programming is done, press
CHANNEL y or z to view the programmed channels.
(Continued on next page)
Programming channels into the TV’s channel memory
+
PA
G E –
ACTION
ENTER
MENU THEATER
NET
FAV
–
100
+10
TouchFocus TV/VIDEO EXIT MENU CHANNEL VOLUME
CHANNEL z / y
TV front panel
CHANNEL y
z
Channel
Numbers