Toshiba 65H93 - Manual (Page 41)

Copyright © 2003 TOSHIBA CORPORATION. All rights reserved. 41
Selecting the menu language
Note: If you already selected the menu language during the
Quick Connect Guide assisted setup, you can skip this step.
You can choose from three different languages (English, French
and Spanish) for the on-screen display of adjustment menus and
messages. (The TV Guide On Screen menus are in English,
regardless of the language selected in this menu.)
To select the menu language:
1. Press MENU and open the PREFERENCES menu.
2. Highlight MENU LANGUAGE and press ENTER.
3. Highlight your preferred menu language in the menu
sidebar and press ENTER.
Preferences
Favorite Channels
Closed Caption Mode • • • Off
Closed Caption Advanced
Input Labeling
Menu Language • • • • English
English
Español
Francais
4. Press EXIT to close the PREFERENCES menu.
Configuring the antenna input
sources
Note: If you already configured the antenna input sources
during the Quick Connect Guide assisted setup, you can skip
this step.
To configure the ANT 1 and ANT 2 input sources:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3 below.)
Setup
Installation
Sleep Timer
On/Off Timer
Digital Tuner Hold • • • • • • • Off
Slide Show Interval • • • 2 Sec
Convergence
3. Open the TERRESTRIAL menu, highlight INPUT
CONFIGURATION, and press ENTER.
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
4. Press • to select the input source (Cable or antenna) for the
ANT 1 input on the TV.
5. Press z and then • to select the input source (Cable or
antenna) for the ANT 2 input on the TV, if applicable. If
you have not connected anything to ANT 2, skip this step.
Input Configuration
Antenna 1 In
Antenna 2 In
Cancel Save
Cable
Antenna
6. To save your new settings: Highlight SAVE and press
ENTER.
To revert to your original settings: Highlight CANCEL
and press ENTER before saving.
Setting up your TV 6
For menu navigation instructions, see Chapter 4.