Toshiba TDP-ET10 - Manual (Page 30)

30
8
Adjusting the volume
The speaker volume can be adjusted by pressing [-] [+] key on control panel or remote
control.
9 Turning off the power
Turn off the power by following the instruction in “Turning the power off” in p.27 .
■ Note
• Note that a lamp characteristics may rarely cause the brightness to fl uctuate slightly.
• A lamp is consumable item. If used for extended periods, images will appear dark,
and the lamp could burn out. This is characteristic of a lamp, and is not malfunction.
(The lifetime of the lamp depends on conditions of use.)
• The DMD TM is made using extremely advanced technology, but there may be black
spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the
panel. Please note that these are not malfunctions.
• Although this projector supports a wide range of RGB signals, any resolutions not
supported by this projector (WVGA) will be expanded or shrunk, which will affect
image quality slightly. To view high-quality images, it is recommended that the com-
puter’s external output should be set to WVGA (854 × 480) resolution.
• With some models of computer having LCD displays or the like, displaying images si-
multaneously on the projector and the monitor’s display may prevent the images from
displaying properly. If this happens, turn off the computer’s LCD display. For informa-
tion on how to turn off the LCD display, see the owner’s manual of your computer.
• If a signal not supported by the projector is input, the “Unsupported signal” will ap-
pear.
• If no signal is being input from the connected device, the “No signal” will appear.
Basic operations (Continued)