Quantum Instruments Cascade Laser Starter Kit - Manual (Page 12)

Starter Kit Instruction Manual Safety Instructions 11
3.3 General safety instructions
• Never attempt to use a system for purposes
other than those detailed in this manual.
• Never attempt to use a system in conjunc-
tion with other instruments without obtain-
ing prior information and approval from the
manufacturer.
• Never attempt to use spare parts other than
those supplied by the manufacturer.
• If an instrument is to be left unused for any
length of time, protect the instrument against
dust and/or humidity.
3.4 Environmental conditions
• Like any other electrical device, the system
must not be located near a water tap.
• The instrument must be kept away from po-
tential sources of interference.
• The system must not be exposed to direct
sunlight, heat, dust or excessive humidity (use
only in a clean laboratory environment).
• Take care not to spill liquid on an instrument.
In the event of accidental spillage, proceed as
follows:
[1] Switch off the instrument immediately.
[2] Unplug the instrument from the mains.
[3] Wipe the instrument down with a dry
tissue.
[4] Check all the electrical functions.
• Ensure sufficient ventilation of the instrument
to prevent overheating.
3.5 Compliance and informa-
tion
In the event of operating faults or other technical
incidents for which a remedy is not described in this
manual, please contact the manufacturer or Alpes
Lasers SA representative immediately.
(http://www.alpeslasers.ch/contacts.htm)