Quantum Audio Travan 40 Tape Drive STT3401A - Manual (Page 99)

ATAPI Interface Chapter 5
Seagate Travan 40 Product Manual Page 91
ATA Command Descriptions
The following ATA commands are supported.
General Feature Set
•
EXECUTE DEVICE DIAGNOSTIC
•
IDENTIFY DEVICE
•
NOP
•
SET FEATURES
ATAPI Feature Set
•
ATAPI ‘DEVICE’ RESET
•
IDENTIFY PACKET DEVICE
•
PACKET
Power Management Feature Set
•
CHECK POWER MODE
•
IDLE
•
IDLE IMMEDIATE
•
SLEEP
•
STANDBY
•
STANDBY IMMEDIATE
Much of this section is taken directly from the ATA-4 specification. Information that is
not relevant to this device has been omitted.
Opcode (Hex) Command Ref. page
00 NOP 107
08 DEVICE RESET 94
90 EXECUTE DEVICE DIAGNOSTIC 95
A0 PACKET 108
A1 IDENTIFY PACKET DEVICE 98
E0 STANDBY IMMEDIATE 113
E1 IDLE IMMEDIATE 106
E2 STANDBY 112