Omega ILD44-UTP - Manual (Page 55)

51
ENTER COMMUNICATION OPTION MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears.
Press d 2) Display advances to INPT Input Menu.
Press a 3) Press a, if necessary, until Display advances to COMM
Communication Options Menu.
Press d 4) Display advances to C.PAR Communication Parameters
Submenu.
If Communication Option is not installed, the display shows NONE
and skips to the Color Display Menu.
COMMUNICATION PARAMETERS SUBMENU:
Allows the user to adjust Serial Communications Settings of the instrument.
When connecting an instrument to a computer or other device, the
Communications Parameters must match. Generally the default settings
(as shown in Section 5) should be utilized.
Press d 5) Display advances to BAUD Baud Submenu.
BAUD SUBMENU:
Press d 6) Display flashes previous selection for BAUD value.
Press b 7) Scroll through the available selections: 300_, 600_, 1200,
2400, 4800, 9600, 19.2K.
Press d 8) Display shows STRD stored message momentarily and then
advances to PRTY only, if it was changed, otherwise press a to
advance to PRTY Parity Submenu.
PARITY SUBMENU:
Press d 9) Display flashes previous selection for “Parity”.
Press b 10) Scroll through the available selections: NO, ODD, EVEN.
Press d 11) Display shows STRD stored message momentarily and then
advances to DATA only, if it was changed, otherwise press a to
advance to DATA Data Bit Submenu.
DATA BIT SUBMENU:
Press d 12) Display flashes previous selection for “Data Bit”.
Press b 13) Scroll through the available selections: 7-BIT, 8-BIT.
Press d 14) Display shows STRD stored message and then advances to
STOP only, if it was changed, otherwise press a to advance to
STOP Stop Bit Submenu.