Omega ILD44-UTP - Manual (Page 24)

20
Input Type (RTD)
ENTER INPUT TYPE MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears.
Press d 2) Display advances to INPT Input Menu.
Press d 3) Display flashes T.ç, RTD or PROC (Thermocouple, RTD or
Process). If the displayed input type is RTD, press a to skip to
step 6 ( RTD stops flashing).
RTD SUBMENU:
Press b 4) Scroll through the available selection to RTD (flashing).
Press d 5) Display shows STRD stored message momentarily and then
RTD (not flashing).
Press d 6) Display flashes previous RTD type selection i.e. 392.2
(see below for RTD types selection).
Press b 7) Scroll through the available RTD types to the selection of
your choice.
Press d 8) Display shows STRD stored message momentarily and then
advances to RTD RTD value.
RTD Types: 392 385 Two, Three or Four-wire
Display:
392.2, 392.3, 392.4, 385.2, 385.3, 385.4
Last digit indicates: 2-, 3- or 4-wire input.
RTD VALUE SUBMENU:
Press d 9) Display flashes previous RTD value selection i.e. 100_
(see below for RTD value selection).
Press b 10) Scroll through the available RTD values to the selection of
your choice.
Press d 11) Display shows STRD stored message momentarily and then
advances to RDG Reading Configuration Menu.
RTD Values: 100 ohm 500 ohm 1000 ohm
Display: 100_ 500_ 1000