Omega ILD44-UTP - Manual (Page 50)

46
3.2.12 Ramp & Soak
Figure 3.11 Flow Chart for Ramp and Soak
ENTER RAMP AND SOAK MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears.
Press d 2) Display advances to INPT Input Menu.
Press a 3) Press a, if necessary, until Display advances to RAMP Ramp
and SOAK Soak Menu.
RAMP ENABLE/DISABLE SUBMENU:
Press d 4) Display advances to “Ramp Enable/Disable” Submenu and
flashes
ENBL or DSBL.
Press b 5) Scroll through the available selections: “Enable” or “Disable”.
Press d 6) Display shows STRD stored message momentarily and then
advances to SOAK Soak Enable/Disable Menu.
If RAMP Disable was selected, display skips to the next menu
item (ID Code).
SOAK ENABLE/DISABLE SUBMENU:
Press d 7) Display flashes ENBL or DSBL.
Press b 8) Scroll through the available selections: “Enable” or “Disable”.
Press d 9) Display shows STRD stored message momentarily and then
advances to “Ramp Value” Submenu.
Alarm must be
DISABLED if Ramp
is ENABLED.
It is recommended that you put the
controller in the Standby Mode for any
configuration change other than
Setpoints & Alarms.