4 access control, Access control – Omega Speaker Systems Dual Thermocouple Over the Internet iSE-TC User Manual

Page 28

4.3.4 Access Control

This section describes the "Access Control" page of the iSE’s Web interface. This page

allows the users to set up the network and security parameters of the iSE.

At the initial entrance to the “Access Control” page you will be prompted for the LOGIN

Password (see Figure 4.6) prior to an ADMINISTRATOR Password.

Figure 4.10 Access Control

Login Password: This allows users to access and modify all of the iSE Home Page menu

items, except “Access Control”, which requires an Administrator password. The default

characters. If there is no Login Password assigned (blank box) the iSE will not require a

password to access and modify iSE Home page menu items.

Admin (administrator) Password: This allows users to access and modify the "Access

Control" page. The default password is 00000000. This password can be up to 16 alpha-

numeric case-sensitive characters. If there is no Administrator Password assigned (blank

box) the iSE will not require password to access and modify "Access Control" page.

Host Name: Refer to Section 3.4, DNS.

MAC Address: This is also called Hardware address or Ethernet address, which is

assigned to the iSE at production. The MAC (Media Access Control) address is the iSE’s

unique hardware number and is not changeable.

IP Address: The IP (Internet Protocol) address is a 32-bit number that identifies each sender

or receiver of information that is sent in packets across the Ethernet or the Internet. The iSE’s

default IP address is 192.168.1.200. The iSE’s IP address should be changed to fit user’s

networking environment. Consult with your IT department for obtaining an IP address.

Gateway Address: A gateway is a network point that acts as an entrance to another

network. A gateway is often associated with a router, which knows where to direct a given

packet of data that arrives at the gateway. If the iSE is sending packets to another network

node that is not on the same network on which the iSE is connected, a gateway address

needs to be given to the iSE. The gateway address should be the IP address of the router

connected to the same LAN to which the iSE is connected. The iSE’s default gateway

address is 0.0.0.0. Consult with your IT department for obtaining a gateway address.

Subnet Mask: It is a 32-bit number that is used to determine which part of the IP address

is the network portion and which part is the host portion. The iSE’s default subnet mask is

255.255.255.0. Consult with your IT department for obtaining a subnet mask.

Camera IP: If there is a networked camera on the LAN, it can be accessed from the iSE’s

Home Page by adding the Camera’s IP address in this field.

ACCESS CONTROL

http://192.168.1.200

Address

Main Menu

Admin Password: 00000000

IP Address: 192.168.1.200

Camera IP: 0.0.0.0

Gateway Address: 0.0.0.0

Camera Label:

Camera Location

Subnet Mask: 255.255.255.0

MAC Address: 00:03:03:00:21:D9

Host Name: eis21d9

Save Reset

Power Recycle

The DHCP can be enabled by

setting the dip switch number 3

to ON position.

Changes made in the iSE’s

Access Control page can be

saved permanently by pressing

the Save button and power

recycling the iSE.

If you change a field and press Save,

this message will appear

Click the following button to activate the new settings.