Omega Speaker Systems Dual Thermocouple Over the Internet iSE-TC - Manual (Page 15)

11
2.9 Flash Memory Format
A 2 Meg flash memory card is included with your product. This memory card is already
formatted; however, the following procedure describes how to format your memory card.
Once the memory card is formatted, all the data that had previously been
recorded will be replaced by simulated test data (see Figure 2.10).
1) Unplug the AC adaptor from the unit.
2) Hold down the ºC/ºF button and connect the AC adaptor back into the unit.
Release the ºC/ºF button.
3) You will see the following message appear on the LCD: *ºWAITº* *FLASH*.
4) Wait for about 60 seconds and a new message should appear: *ºWAITº* *OKAY*.
5) Press the ºC/ºF button once and this message will appear: DATA-RECORD-TEST.
6) Press the TIME button and this message will appear: DATA RECORD TEST -
DATA RECORD TEST.
8) Again, press the ºC/ºF button, the firmware version will appear, followed by
*OKAY*.
9) Unplug the AC adaptor and plug it back in. The flash memory card is now
formatted. To verify whether the formatting was completed correctly, you should be
able to see the following graph on the WEB server’s “Chart” page.
Figure 2.10 Chart of Simulated Data