Omega Speaker Systems Dual Thermocouple Over the Internet iSE-TC - Manual (Page 22)

18
4.2 Setting a New IP Address over the Network
Besides using the iConnect software, you may use the iSE’s default IP address to
access it and assign a new IP address to it.
The iSE is shipped with a default IP address of 192.168.1.200 and Subnet Mask of
255.255.255.0. You can configure your PC’s Network connection with an IP address that
is in the same range as the iSE’s IP address (192.168.1.x) and connect to the iSE using a
crossover network cable between your PC and the iSE.
With this completed, you can go to the DOS-Prompt and ping 192.168.1.200. If you
receive responses back (Figure 4.1), you can go to a Web browser and type in
http://192.168.1.200 and it will take you to the iSE’s main web page.
Select , button, you’ll be asked for the password. The default LOGIN
password is "12345678" and the ADMINISTRATOR password is "00000000", then you
should be on the Access Control page were you can simply type in the desired Static IP
address, and click Save.
Figure 4.4 Access Control
For the IP address to take effect, the iSE needs to be turned OFF/ON. Clicking the
“Power Recycle” button will turn the iSE OFF and ON. Pressing the physical button
marked “RESET” on the iSE does the same thing.
You can now connect the iSE to an Ethernet hub using a straight through cable, power it
up, and follow the ping routine mentioned in the previous section.
ACCESS CONTROL
ACCESS CONTROL
http://192.168.1.200 Address
Main Menu
Login Password: 12345678
Admin Password: 00000000
IP Address: 192.168.1.200
Camera IP: 0.0.0.0
Gateway Address: 0.0.0.0
Camera Label: Camera Location
Subnet Mask: 255.255.255.0
MAC Address: 00:03:03:00:21:D9
Host Name: eis21d9
Save Reset
Power Recycle
Access Control
Click the following button to activate the new settings.