Omega Speaker Systems Dual Thermocouple Over the Internet iSE-TC User Manual
Page 10
6
2.2 DIP Switches
The iSE is shipped with all DIP switches in "OFF" position.
Figure 2.3 DIP Switch Location
To set the iSE to factory default settings, slide DIP switch #2 to ON position. Power the
iSE on and wait about 10 seconds until the iSE fully boots up. Set the DIP switch #2
back to OFF position (it does not matter if the iSE is powered ON or OFF, just make
sure that the DIP switch is set to OFF, otherwise, every time the unit is power-cycled
the factory settings will take over.
To enable the DHCP, besides using DIP switch #3, set the iSE’s IP address to 0.0.0.0.
An iSE with IP address of 0.0.0.0 will request an IP address, gateway address, and
subnet mask from the DHCP server over the Ethernet
DIP Switch Usage
1) N/C - not used
2) To change to default factory settings
3) To enable/disable DHCP
4) N/C - not used