Onkyo TX-DS575x - Manual (Page 35)

35
Programming the remote controller codes of other devices into the RC-392M
See page 39 for information on how to erase the learned codes from all buttons.
You can erase a learned code. You cannot erase preset codes.
•
Erasing a code programmed in a button
1. Press and hold down the corresponding MODE button and
press the ENT button, then release the buttons.
When you press the MODE button, the SEND/LEARN indica-
tor lights up. When you press the ENT button, the indicator
turns off. When you release the buttons, the indicator lights up
again.
2. Press and release the button from which you wish to erase
the learned code.
When you press the button, the SEND/LEARN indicator turns
off. When you release the button, the indicator lights up again.
3. Press and release the same button again.
The SEND/LEARN indicator flashes twice slowly. The learned
code is erased.
Note:
•
If you do not press the button in step 2 or 3 for more than 30 sec-
onds, the SEND/LEARN indicator flashes three times quickly,
then the RC-392M exits Learning mode. Resume Step 1.
1. Press and hold down the MODE button from which you
wish to erase the learned code, and press the ENT button
twice. Then release the buttons.
When you press the MODE button, the SEND/LEARN indica-
tor lights up. When you press the ENT button, the indicator
turns off. When you release the buttons, the indicator flashes
twice slowly, then lights up again.
2. Press and release the same MODE button again.
When you release the button, the SEND/LEARN indicator
flashes twice slowly. The learned code is erased.
Note:
•
If you do not press any button for more than 30 seconds, the
SEND/LEARN indicator flashes three times quickly, then the
RC-392M exits Learning mode. Resume Step 1.
•
If you make a mistake during programming, the SEND/LEARN
indicator flashes three times quickly, the RC-392M exits Learn-
ing mode. Resume Step 1.
•
If have programmed many button operations to a single MODE
button, the SEND/LEARN indicator may remain illuminated
continuously in Step 2. This is not malfunction.
Erasing a learned code
Erasing a learned code from a MODE button
SEND/LEARN
indicator
MODE
buttons
ENT
SEND/LEARN
indicator
MODE
buttons
ENT