Onkyo TX-DS575x - Manual (Page 31)

31
Using the remote controller
Overview
When you use a remote controller, typically you press one of the MODE buttons that corresponds to the device you wish to control, then
press the operation buttons. For example, if you wish to control the TX-DS575X from a remote controller, first press the MODE AUDIO but-
ton, then press an appropriate operation button. To control a CD player, press the MODE CD button, then press an appropriate operation but-
ton.
First, press the desired MODE button to make sure that the TX-DS575X is set to a correct mode.
Using the RC-392M to control each device
Note:
Before operating the RC-392M, turn on the POWER switch on the
TX-DS575X so that the unit enters standby mode.
1. Press the MODE AUDIO button.
2. Pressing the ON button will power on.
Pressing the STNBY button will power standby.
SEND/LEARN indicator
This indicator acts as a guide when commands are programmed
into or sent by the remote controller. It also warns the user when
an error is made or battery power is low.
1. Press the MODE AUDIO button.
2. Press the desired operation button.
Shaded buttons in the figure are the operation buttons used to
control the TX-DS575X.
SLEEP : Sleep function
ON/STNBY : Power on/standby
DISPLAY : Changing the display
VOL q / u : Adjusting the volume
CH +/– : Tuner preset number increment/decrement
INPUT SELECTOR
Listening mode ( STEREO / DSP √ / DSP ® / SURROUND )
: Changing Listening mode
SP A/SP B : Switching between Speakers A and B
CH SEL : Selecting a speaker
DIMMER : Adjusting the brightness of the display
LEVEL +/– : Adjusting the speaker levels
TEST : Test tone
MUTING : Muting
LIGHT : Iluminating the buttons.
Turning the power on and off to the TX-DS575X
Controlling the TX-DS575X
MODE
AUDIO
CH +/-
SP A/B
DISPLAY
STNBY
LIGHT
VOL
MUTING
Listening
mode
LEVEL +/-
DIMMER CH SEL
INPUT
SELECTOR
TEST
ON
SLEEP
MODE AUDIO
STNBY ON
SEND/LEARN
indicator