Onkyo TX-DS575x - Manual (Page 19)

19
Selecting a sound source
Follow the steps below to adjust the level of each speaker if you
have selected MULTI CH INPUT.
1. Press MODE AUDIO button on the remote controller.
2. Press MULTI CH button on the remote controller.
You cannot select any listening mode.
3. Play the device connected to the MULTI CHANNEL INPUT
jack.
4. Adjust the volume level of each speaker.
4-1. Press the CH SEL button to select the desired speakers.
4-2. Use the LEVEL +/– button to change the volume level of
the speakers.
You can adjust the volume level of each speaker individu-
ally. Adjust the level while listening to the sound in the lis-
tening position.
You can adjust the level of the front, center, and surround
speakers in the range between –12dB and +12dB.
You can adjust the subwoofer level in the range between –
30dB and +12dB.
Note
•
Adjusting the volume level of each speaker for the MULTI CH
INPUT source does not affect the speaker level adjusted by the
Test Tone function, and vice versa.
•
If the speaker level is set to +1dB or higher, the maximum level
indicated on the display will change if you raise the volume
level. Refer to “About volume (VOLUME)” on page 20 for
more information.
This function automatically selects the volume level you set last
time.
Follow the steps below:
How to set the Power On Volume function:
1. Press the SP/SYS SETUP button repeatedly to select
“POWER ON VOLUME.”
2. Press the ENTER/SCAN or ENTER button.
The unit displays “PWR ON VOL=OFF” or the current volume
level.
If “PWR ON VOL=OFF” appears, press the PRESET/MODE
ADJ√/® button to display the current level (PWR ON
VOL=XX).
3. Use the MASTER VOLUME control to set the desired level.
4. Press the ENTER/SCAN or ENTER button to complete the
setting.
Note:
If the PWR ON VOL parameter is set to OFF, the Power On Vol-
ume function is disabled. In this case, when you turn on the power
to the unit next time, it will use the volume level that was set when
you turned off the power.
When Multi channel input is selected as a source
Using the Power On Volume function
LEFT
L-SURROUND
CENTER RIGHT
R-SURROUND SUBWOOFER
2
4-1
4-2
1
ENTER / SCAN
ENTER
2
3
1
SP/SYS
SETUP
ENTER / SCAN
ENTER
PRESET / MODE ADJ
DOW N UP
U P
MASTER VOLUME
D O W N
4
or
or