Onkyo TX-DS575x - Manual (Page 17)

17
Selecting a sound source
AV RECEIVER TX-DS575X
TREBLE BASS
PHONES
OFF ON
STANDBY/ON
STANDBY
SPEAKERS A B
FM AM PHONO C D
TAPE
DVD MULTI CH INPUT
VIDEO 3 VIDEO 2 VIDEO 1
U P
DOWN
MASTER VOLUME
POWER
SP / SYS SETUP
MODE
TUNING UP DOWN CH LEVEL MEMORY FM MUTE /
MODE DIGITAL/
ANALOG PTY/TP
DOWN UP
PRESET/MODE ADJ
ENTER/SCAN
LATE NIGHT / FRONT EFFECT
DISPLAY
LFE LEVEL CONTROL STEREO 5 CH STEREO DSP LISTENING MODE
/DTS SURROUND Re -EQ STEREO 5 CH STEREO DSP LISTENING MODE
/DTS SURROUND
1. Press the desired input selector button or
MULTI CH INPUT button.
The selected source name appears on the display. If
you have selected DVD, CD, VIDEO 1, VIDEO 2,
VIDEO 3, or TAPE, see page 18. Refer to page 19
for more information on MULTI CH INPUT.
2. Make sure that the SPEAKERS
A indicator is lit on the display.
If it is not lit, press the
SPEAKERS A button.
(Refer to the “Speakers selector”
section on the page 20 for more
details.)
3. Start playing the selected input
source.
Follow the operating instructions
for the source device.
5. Adjust the volume to an appropriate level.
These controls allow you to adjust the volume of the
Front, Center, Surround speakers and subwoofer
simultaneously. Turning the control clockwise
increases the volume level. Turning the control
counter-clockwise decreases the volume level.
(Refer to page 20 for more details.)
DIMMER button (other than
European models)
Use this button to change the brightness
of the display (normal or dim).
5. VOLUME button (qup/udown)
Use this button to adjust the
volume level.
3. INPUT SELECTOR button
Use this button to select a desired sound source.
(V4 button is not used for this TX-DS575X.)
DIMMER button
Use this button to change the brightness
of the display (normal or dim).
SLEEP button
This button allows you
to set the sleep timer.
(Refer to page 20 for
more details.)
MUTING button
This button mutes the sound temporarily.
(Refer to page 20 for more details.)
6. Use the bass, treble
controls to adjust the tone.
(Refer to page 20 for more
details.)
1. Press the MODE AUDIO button
4. LISTENING MODE
Select a Listening mode.
(Refer to page 21)
2. SP A button
Use this button
to select Speaker A.
4. Select a Listening mode. (Refer to page 21)
PTY/TP button (European models only) (Refer to page 27)
Follow the steps below to select a device to play the sound source.
Warning:
•
Do not play CD-ROM discs that contain computer data as they may damage the speakers when the sound is amplified by the receiver.
Note:
If you hear no sound from the speakers, check the following items:
•
Make sure that all devices and speakers are connected correctly and securely.
•
The sound is muted when the “MUTING” is on the display. Press the MUTING button on the remote controller to cancel the mute func-
tion.
•
When you select a source that is connected to the DIGITAL INPUT jacks on the rear panel. Check to see if the audio (digital or analog)
selection is correct (when DVD, CD, VIDEO 1-3, or TAPE is selected) (refer to page 18.).
•
If you have selected MULTI CH INPUT, you need to adjust the level of each speaker (refer to page 19).