Omega RD260A - Manual (Page 14)

2 - 2
2.1.2 Mounting Methods
(1) Mount the recorder on a steel panel whose thickness is at least 2 mm (and up to 26
mm).
(2) Insert the recorder into the panel-front face.
(3) Fix the recorder to the panel using the mounting brackets as shown below.
Adequate screw tightening torque is approximately 8 to 12 kg-cm. A pair of
mounting brackets can be applied to the recorder’s top and bottom, or to both side
faces. Remove the seals covering the holes for the brackets before attaching them.
A tightening torque exceeding the above-mentioned adequate values may
cause deformation of the recorder case or brackets.
Mounting bracket
Mounting
CAUTION